The customer requires ST-LINK to program the chip. How do I integrate it into my host computer program? How do the labview and the programmer interact with data?
Corbett ポストする January 6, 2021
1. General burners have command line burning commands. Look at the manual, and see if there are any commands similar to DOS, which can be executed with the CMD function of LabVIEW.
2. In addition to the command line, there may be calls such as DLLs. This kind of complexity requires reading the instructions.
Wafa ポストする January 6, 2021
The writer usually connects with the PC through the serial port, communicates through the labview serial port, and then transmits the corresponding programming instructions.
Oleg ポストする January 6, 2021
You can use VBS to control the burner software and perform shortcut key control.
Neville ポストする January 6, 2021
Execute system command function.
