![]()
To make a pre-amplifier circuit, please ask how to make this circuit into a single power supply. There is room for improvement on this road, so please mention it, thank you.

Dannie ポストする July 22, 2020
If you change to a single power supply, the landlord must choose 24v and choose a reference 0V point

Flint ポストする July 22, 2020
It's very simple, just use two resistors of the same resistance (10k~100k) to divide the voltage of VCC (12V in the question), and then connect to the positive phase terminals of the two op amps.