Do you have a suitable circuit
Requires input signal 1V, bandwidth 0~100MHZ, input 1V, output 9V, 1A.
Luca ポストする September 4, 2020
You go to TI or ADI to see if there are any ready-made chips.
Ricardo ポストする September 4, 2020
It is estimated that a film is choking, and visual inspection may require multiple levels.
Elena ポストする September 4, 2020
It is too difficult to set a bandwidth of 0-100M, so it should be done separately and switched between different frequency bands. No amplifier has good linearity from extremely low frequencies to such high frequencies.
