As in the question, it runs normally when using Jlink for debugging, but it will not work once Jlink is unplugged. It is found through the running indicator that the system has not started at all. Does anyone know the reason?
Maurice ポストする January 8, 2021
Is there any setting to start execution from main after downloading?
Linda ポストする January 8, 2021
Does unplugging Jlink disconnect JLINK from the circuit board or from the PC? If the circuit board is disconnected, do you try to reset it?
Tomas ポストする January 8, 2021
Is there a problem with the reset pin? Or you set it to run the program in ram.
